Toshiba e-STUDIO 5540C Service Manual page 193

(4) Disconnect the connector of the exposure
lamp.
Notes:
When disconnecting the connector, pay
attention not to give load to the carriage
frame.
(5) Release the harness from the harness
clamp.
(6) Move the carriage-1 to the position where
the side of the frame is cut out.
(7) Remove 1 screw.
(8) Lift up the front side of the exposure lamp
and take off by sliding it.
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
Fig. 4-51
Fig. 4-52
Exposure lamp
Fig. 4-53
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
4 - 19
DISASSEMBLY and REPLACEMENT
4