[EA70] Stack exit belt home position error
Classification
Finisher jam
(Finisher section)
Check item
Stack belt exit home position sensor
(S9)
Stack transport motor (M5)
Finisher controller board
Upper surface detection sensor
Replace parts
Stack belt exit home position sensor
(S9)
Stack transport motor (M5)
Finisher controller board
8.3.10
Paper jam in saddle stitcher section
[EA90] Door open jam
Classification
Finisher jam
(Saddle stitcher section)
Check item
Finisher, saddle stitcher
Delivery cover sensor (PI3)
Inlet cover sensor (PI9)
Saddle stitcher controller board
Replace parts
Delivery cover sensor (PI3)
Inlet cover sensor (PI9)
Saddle stitcher controller board
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
The stack exit belt is not at the home position. [MJ-1103/1104]
•
Sensor check
•
Connector check
•
Harness check
•
Motor check
•
Connector check
•
Harness check
•
Connector check(CN10, CN11)
•
Board check
•
Refer to CB31
The delivery cover or inlet cover has opened during printing
[MJ-1104]
•
Check if there is any paper in the finisher, saddle stitcher
or the on the transport path of the equipment. Remove it if
there is.
•
Sensor check
•
Connector check
•
Harness check
•
Sensor check
•
Connector check
•
Harness check
•
Connector check(J10, J11)
•
Board check
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
8 - 95
Error item
Measures
Remarks
Error item
Measures
Remarks
ERROR CODE and TROUBLESHOOTING
8