4.9.3
Transport guide-1
(1)
Take off the fuser unit.
P. 4-172"4.9.1 Fuser unit"
(2)
Take off the pressure roller cover.
P. 4-173"4.9.2 Pressure roller cover"
(3)
Remove 2 screws and then take off the
transport guide-1 [1].
Notes:
When installing, fully tighten the 2 pressure
screws until they are no longer turned.
Notes:
Place transport guide 1 as shown in the
figure so that its separation finger [1] does
not become damaged.
4.9.4
Transport guide-2
(1)
Take off transport guide-1.
P. 4-172"4.9.1 Fuser unit"
(2)
Remove 2 screws and take off transport
guide-2 [1].
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
DISASSEMBLY and REPLACEMENT
[ 1 ]
[ 1 ]
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
4 - 174
Fig. 4-499
[ 1 ]
[ 1 ]
Fig. 4-500
Fig. 4-501