Toshiba e-STUDIO 5540C Service Manual page 998

Replace parts
[2E45] Meta data creation error in USB storage (Scan to File)
Classification
File sharing related error
Check item
Setting
Replace parts
[2E65] File creation error due to insufficient USB folder capacity
Classification
File sharing related error
Check item
Setting
Replace parts
[2E66] HDD full failure in USB storage
Classification
File sharing related error
Check item
Setting
Replace parts
[2EC1] Power failure in USB storage
Classification
File sharing related error
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
Creation of meta data failed.
Check the template settings. Perform the job in error again. If
the error still occurs, turn the power OFF and then back ON,
and then perform the job in error again.
Creation of a new file failed because there were too many
files in the USB folder
Delete unnecessary files in the folder.
HDD became full while storing data in HDD.
Delete the job in progress or being set or in the HOLD/
PRIVATE/PROOF/INVALID, and perform it again.
Check if the server or local disk has a sufficient space in disk
capacity.
Check that there is enough space in the USB memory.
Power failure occurred.
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
8 - 242
Remarks
Error item
Measures
Remarks
Error item
Measures
Remarks
Error item
Measures
Remarks
Error item