(5)
Cut the harness band to release it from the
clamp.
(6)
Remove 2 screws and take off the bridge unit
cooling fan (rear) from the bracket.
4.10.32 Front cover opening/closing detection switch (SW9) / Bridge unit
connecting detection switch (SW8)
Notes:
When the front cover opening/closing detection switch (SW9) is replaced or removed, be sure to
perform the operation check with the output check (test mode 03).If the installation is insufficient,
this switch is not performing properly. In this case, you may touch the rotating portions such as
the gear in the toner motor during the drive and could be injured as a result.
(1)
Take off the switch brackets.
P. 4-135"4.6.52 Toner motor interlock
switch (SW3)"
(2)
Disconnect a connector and then take off the
front cover opening/closing detection switch
from its bracket.
(3)
Take off the bridge unit connecting detection
switch from its bracket.
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
Bridge unit cooling fan (rear)
Fig. 4-688
Front cover opening/closing detection switch
Fig. 4-689
Bridge unit connecting detection switch
Fig. 4-690
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
4 - 237
DISASSEMBLY and REPLACEMENT
4