Toshiba e-STUDIO 5540C Service Manual page 907

[CC20] Communication error between finisher and saddle stitcher
Classification
Finisher related service call
Check item
Equipment
Finisher control PC board (FIN)
Saddle control PC board (SDL)
Replace parts
Finisher control PC board
Saddle control PC board
[CC30] Stack transport motor abnormality
Classification
Finisher related service call
Check item
Stack transport belt
Stack transport motor (M5)
Finisher control PC board (FIN)
Replace parts
Stack transport motor
Finisher control PC board
[CC31] Transport motor abnormality
Classification
Finisher related service call
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
Communication error between finisher controller PC board
and saddle stitcher controller board [MJ-1103/1104]
• Is the problem solved by turning OFF and ON the power
switch of the equipment?
• Connector check
• Board check
• Connector check
• Board check
The stack transport motor is not rotating or the stack transport
belt is not moving normally. [MJ-1103/1104]
You receive a [CC30] error when the [EA70] error occurs
three times in succession.
• Is there any mechanical problem when the stack transport
belt is moved?
• Motor check
• Connector check
• Harness check
• Connector check (CN10)
• Board check
The transport motor is not rotating or the stack transport roller
-1 and -2 is not rotating normally. [MJ-1103/1104]
You receive a [CC31] error when the [ED12] error occurs
three times in succession.
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
8 - 151
Error item
Measures
Remarks
Error item
Measures
Remarks
Error item
ERROR CODE and TROUBLESHOOTING
8