Image Dislocation In Feeding Direction - Toshiba e-STUDIO 5540C Service Manual

8.5.22

Image dislocation in feeding direction

Cause/Section Step
Adjustment 1
error of
scanner or
printer section
Registration 2
roller
3
4
Paper feed 5
clutch,
Transport
clutch
Aligning 6
amount
Each roller 7
8
Registration 9
guide
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
ERROR CODE and TROUBLESHOOTING
Fig.8-31
Check item
Is same dislocation on every copy?
Is the registration roller dirty, or is the
spring removed?
Is the registration motor
malfunctioning?
Is the registration motor operating
normally? (Is the timing of operation
delaying?)
Are the paper feed clutch and
transport clutch malfunctioning?
Is the aligning amount proper?
Are the roller and shaft not fixed
securely?
Is the roller surface dirty?
Is the registration guide improperly
installed?
Adjust the scanner/printer using the
Adjustment Mode.
Clean the roller with alcohol.
Reinstall the spring.
Adjust or replace the gears, etc. if
they are not engaged properly.
Replace the registration motor.
Check the circuit or the clutch and
replace them if necessary.
Decrease the aligning amount.
Check the E-ring, pin and clip.
Clean the roller surface with alcohol
or replace it.
Reinstall the guide.
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
8 - 330
Measures