JVL MIS17 Series User Manual page 82

4.1
4.1.4 Main Screen
4.1.5 I/O Setup tab
Active level for the I/Os
can be chosen to high or
low on inputs
Dedicated Inputs
Selection for Inputs
HM, NKL and PL
An external encoder can
also be selected here and
defined as either quadrature
or pulse/direction type.
Selection if it shall
be Inputs or Outputs
Dedicated Outputs
Selection for outputs "In position",
"In Physical Position", "Error"
output. It can also be selected
if the pulses generated shall be
used internally, externally or both
and which output should be used
for pulse and direction signals
*) The analogue value of certain inputs can be read. Click at the input lamp and the ana-
logue value will be shown. The upper value is the actual value and the lower value the
filtered value.
**) If the IO's are setup as output(s) they can be activated with a click at the output
"LED" in the status window. At the same time the digital and analogue input are activated
since they share the same I/O terminal. This can be very usefull in test situations when
the motor is not installed in the final application with all I/O signals connected.
82 JVL Industri Elektronik A/S - User Manual - Integrated Stepper Motors MIS17x, 23x, 34x, 43x
Using the MacTalk software
TT2183-02GB
Input filters
Here the filter for the
digital inputs can be selected.
Filter time constant can be adjusted here.
The same value is used for all inputs if filter
inputs are enabled.
Selection of Inputs for
HM, NL and PL
Selection of output for
In-Position and Errors
Status of the inputs *)
Status of the outputs **)