JVL MIS17 Series User Manual page 214

8.2
8.2.69 Turntable_Mode
Reg Name
TURNTABLE_
126
MODE
Description: In turntable mode, the motor controls the revolution of a turntable that has the number
of positions specified in register 127, Turntable_Size.
This means the same position will be reached after rotating this number of steps in either
direction.
This register selects one of three modes that define how the motor should move to a
new position when the P_SOLL register is changed.
If the value of this register is zero, the motor will not operate in turntable mode.
Several modes of operation exist. Please also see
description.
8.2.70 Turntable_Size
Reg Name
TURNTABLE_
127
SIZE
Description: If turn table mode is selected in register 126, the number of steps needed for a full rev-
olution of the turn table is set in this register. Note that the register P_SOLL must always
have a value between zero and the value in this register minus one. Negative values are
not allowed for P_SOLL or Turntable_Size.
Please also see
8.2.71 NL_Mask
Reg Name
129 NL_MASK
Description: Selects which one of the eight IO pins to use for the dedicated function of Negative Po-
sition Limit.
Exactly one bit must be set, and the IO pin must be configured in register 125 as an
input.
Example: If input 7 is to be used for the Negative Input Limit, write 26 = 64 to this
register.
214 JVL Industri Elektronik A/S - User Manual - Integrated Stepper Motors MIS17x, 23x, 34x, 43x
Internal registers
Size Access Range
32bit R/W 0 - 6
Size Access Range
32bit R/W -
Turn Table Mode, page 139 for detailed description.
Size Access Range
32bit R/W -
Default Unit
0 Special
Turn Table Mode, page 139 for detailed
Default Unit
0 Steps
Default Unit
0 IO Mask
MacTalk name
Turn Table Mode
MacTalk name
Turn Table - Size
MacTalk name
Dedicated Inputs
Negative Limit Input