Using The Mactalk Software - JVL MIS17 Series User Manual

4.1
4.1.1 MacTalk introduction
The MacTalk software is the main interface for setting up the MIS motor for a specific
application.
The program offers the following features:
- Selection of operating mode of the MIS motor.
- Changing main parameters such as speed, motor current, zero search type, etc.
- Monitoring in real time the actual motor parameters, such as supply voltage, input
status, etc.
- Changing protection limits such as position limits.
- Saving all current parameters to PC.
- Restoring all parameters from PC.
- Saving all parameters permanently in the motor.
- Updating the motor firmware or MacTalk software from the internet or a file.
The main window of the program changes according to the selected mode, thus only
showing the relevant parameters for operation in the selected mode.
The following pages describe the actual window for each mode and how the parameters
affect MIS motor operation.
MacTalk is normally connected through the RS485 interface but may also work on Ether-
net (if the Ethernet option is present in the actual motor).
78 JVL Industri Elektronik A/S - User Manual - Integrated Stepper Motors MIS17x, 23x, 34x, 43x

Using the MacTalk software