JVL MIS17 Series User Manual page 344

16.4 Gear and brake mounting instruction
3
344 JVL Industri Elektronik A/S - User Manual - Integrated Stepper Motors MIS17x, 23x, 34x, 43x
Step 3 - Final stage. Fasten the shaft collar with a torque of according to
the scheme below.
Please notice that it can be fatal not to use the specified torque since the
shaft may slip over time and cause a position offset.
Gears (Product type to be mounted)
Series Used with motor type
HTRG05 MAC050 to MAC141
HTRG05 MIS230-233
HTRG06 MAC050 to MAC141
HTRG06 MAC400-402
HTRG08 MIS340-341
HTRG08 MIS342
HTRG08 MAC800
HTRG10 MAC800
Brakes (Product type to be mounted)
Series Used with motor type
MAB23x MAC050 to MAC141
MAB23x MIS230-233
MAB34x MIS340-341
F1
Use a precise torque wrench
to fasten the screw in the shaft collar.
(Ø6.35 shaft)
(Ø6.35 shaft)
(Ø6.35 shaft)
(Ø14 shaft)
(Ø9.53 shaft)
(Ø14 shaft)
(Ø19 shaft)
(Ø19 shaft)
(Ø6.35 shaft)
(Ø6.35 shaft)
(Ø9.53 shaft)
Tool Torque
(F1)
5Nm
Hex size 3
5Nm
Hex size 3
5Nm
Hex size 3
11Nm
Hex size 3
5Nm
Hex size 4
8Nm
Hex size 5
11Nm
Hex size 5
11Nm
Hex size 5
Tool Torque
(F1)
2Nm
Hex size 2.5
2Nm
Hex size 2.5
5Nm
Hex size 3
TT1537-01GB