JVL MIS17 Series User Manual page 32

2.4
Load
2.4.2 General
The Controller is equipped with a total of 8 digital outputs. Each output can be used for
a variety of purposes depending on the Controller's basic mode of operation. The Out-
puts are not galvanically isolated from other circuitry in the motor.
The output circuitry is powered from the control voltage supply terminal CVI.
See also Control Voltage (CVI terminal), page 15.
The output circuitry operates with voltages in the range 7-28VDC.
Each output can supply a continuous current up to 350mA (max).
The outputs are all source drivers, i.e. if a given output is activated, contact is made be-
tween the control voltage (CVI) and the respective output terminal. See above illustra-
tion.
2.4.3 Overload of User Outputs
All of the outputs are short-circuit protected, which means that the program and the mo-
tor is stopped and the output is automatically disconnected in the event of a short circuit.
The output will first function normally again when the short-circuit has been removed.
Note: Do not connect a voltage greater than 30VDC to the CVI terminal as the output
circuitry may be seriously damaged and the unit will require factory repair.
If one or more outputs are short circuited, MacTalk will show Error "Output Driver" and
Bit 2 will be set in Err_Bits.
See also Err_Bits, page 201.
32 JVL Industri Elektronik A/S - User Manual - Integrated Stepper Motors MIS17x, 23x, 34x, 43x
User Outputs
+24VDC Nom.
For optional supply
of external sensor
Max. 350 mA or similar max. 700 mA
Screen
Ground
Note ! : screen only
connected to signal source.
MISxxx User Outputs
MISxxx Motor
CVO
(Derived from CVI)
IO1
(Input/output 1)
IO2
(Input/output 2)
IO3
(Input/output 3)
IO4
(Input/output 4)
IO5
(Input/output 5)
IO6
(Input/output 6)
IO7
(Input/output 7)
IO8
(Input/output 8)
GND
(Derived from P-)
TT2510-02GB