JVL MIS17 Series User Manual page 217

8.2
8.2.78 Acceptance voltage
Reg Name
139 Acceptance Voltage
Description: The acceptance Voltage, is the voltage required at the CVI supply terminal (PWR con-
nector) for the program to start up.
The typical and recommended nominal voltage is 24VDC but if a lower voltage is used in
for example battery powered applications please make sure that the acceptance voltage
also covers that the battery is much lower than if its fully charged.
8.2.79 Acceptance count
Reg Name
140 Acceptance Count
Description: Acceptance Count is the n umber of times a voltage above the acceptance voltage must have
been measured before the program starts.
The basic idea behind this register/function is to make sure that the startup is completed
and the supply voltage is stable.
JVL Industri Elektronik A/S - User Manual - Integrated Stepper Motors MIS17x, 23x, 34x, 43x
Internal registers
Size Access Range
32bit R/W 32bit
Size Access Range
32bit R/W 32bit
Default Unit
2052
8.764 mV
(18 Volt)
Default Unit
100 -
MacTalk name
Acceptance
Voltage
MacTalk name
Acceptance Count
217