User Outputs - JVL MIS17 Series User Manual

2.4
2.4.1

User outputs

The MIS motors has 8 inputs/outputs (IO's) that each can be set individually to input, out-
put or analogue input 0-5V via MacTalk or software commands.This means that it for ex-
ample is possible to have 4 inputs, 3 outputs and one analogue input.
!
Input/output functional diagram (only one I/O shown)
Internal µ-Processor
TT2423-02GB
• The Outputs are Source outputs and 7-28VDC compliant
• No galvanic isolation
• Short-circuit to ground protected that shuts down all outputs and sets Error bit in
software.
• Optional "In Position" and "Error" signals can be selected to be on any outputs 1 to 8
• Optional Encoder outputs
• 350 mA output current per channel even with all channels fully loaded at the same
time.
• Internal ground clamp diodes to protect when inductive load is driven.
JVL Industri Elektronik A/S - User Manual - Integrated Stepper Motors MIS17x, 23x, 34x, 43x
User Outputs
Please notice: The number of available I/O terminals available may differ de-
pending at which motor type and connector configuration you are using. Please
consult the chapter Connector overview for the MIS
Over current and
temperature protection
Digital output
Digital input
Analog input
Power
MosFet
Transistor
+5V
4k7
100pF
GND GND GND
motors, page 37
Over voltage
protection
CVI (only input)
Polyfuse
750mA
CVO (only output)
(max 700mA)
IO1 to IO8
(Only one I/O shown)
10kOhm
31