JVL MIS17 Series User Manual page 123

5.8 Absolute Multi-turn Encoder
5.8.2 How to Preset the encoder position.
After installing the motor it is normally desired to make an alignment of the encoder po-
sition which represent the "Actual position" compared to the actual physical position of
the motor and its load.
This operation is recommended to do in the following manner.
1. Set the motor in a known position
2. Insert the corresponding position value as shown below.
3. Press the "Set position" button to preset the new position value.
4. The encoder position and all other relevant position registers are now preset with
the new value. No further action is needed. The motor will remember this change
also during power off.
JVL Industri Elektronik A/S - User Manual - Integrated Stepper Motors MIS17x, 23x, 34x, 43x
Only MISxxx---H3/H4--
123