JVL MIS17 Series User Manual page 152

6.4
After this program has been executed, the external source must be connected to the fol-
lowing inputs:
Quadrature format
Channel A
Channel B
Please note that the MIS motor family offers different connector configurations.
For specific details about at which connectors the I/O terminals are available please con-
sult: - Connector overview for the MIS
6.4.5 General considerations concerning cabling.
It is strongly recommended that shielded cable is always used when connecting the ex-
ternal pulse source to the pulse input to ensure that no noise from the surroundings af-
fect the quality of the signal and worst case cause the motor movement to get affected.
Also a good, solid ground wire between the motor and the source is recommended since
any differences in the potential between the pulse source and the motor can affect the
motor movement.
General guidelines concerning the I/O's are given in the following chapters:
- User Inputs, page 21 or General, page 32.
152 JVL Industri Elektronik A/S - User Manual - Integrated Stepper Motors MIS17x, 23x, 34x, 43x
Gear Mode
I/O terminal
IO2
IO3
motors, page 37.
Pulse/direction format
Pulse
Direction
I/O terminal
IO2
IO3