Schlage PIB300 User Manual page 228

Networking and Communications
Align a bubble level with the top edge of the wall plate and gently rotate the
5.
wall plate until the bubble level shows that the totp edge of the wall plate is
level.
Secure the plate to the wall using heavy masking tape.
6.
Using the wall plate as a template, mark the locations of teh two upper
7.
screw holes and the three lower screw holes.
For a concealed wiring connection, trace the outline of the open area in the
8.
center of the wall plate. Identify and mark a 1/2 inch hole through which the
HandPunch's wiring will be mounted.
For a surface conduit wiring connection, mark the two conduit clamp holes
9.
at the right side of the wall plate.
Remove the wall plate, masking tape, and the nail (if used).
10.
Mounting the
1.
Wall Plate
2.
Routing the
1.
Wiring
2.
24
For a hollow wall, use the provided hardware to mount the wall plate. Use
the two auger style fasteners for teh upper two mounting holes. Use the
toggle bolts for the three lower mounting holes.
For a solid wall, use expansion bolts to mount the wall plate. For all five
mounting holes, drill a 1/4 inch diameter hole, 1/4 of an inch deeper than
the length of the expansion anchor.
For a concealed wiring connection, drill a 1/2 inch hole in a convenient
location within the open area of the wall plate. Pull the wiring to enter the
HandPunch through this hole in the open area.
For a surface conduit wiring connection, drill a 1/4 inch diameter hole, 1/4
of an inch deeper than the length of the expansion anchor for each of the
two conduit clamp holes. Route 1/2 inch conduit to the HandPunch, ending
the conduit between the two conduit clamp holes. Pull the wiring to enter
the HandPunch through the conduit.