Panasonic FP-E Programming Manual page 298

High−level Instructions
Description
S2 blocks of data stored in the EEPROM starting from S1 are transferred into the data register specified by D.
At this time, the transferred data is handled in units of 1 block/64 words.
Precautions during programming
Values that can be specified by S1, S2 and D
Type yp
FP0 C10, C14, C16, FP−e
FP0 C32, SL1
FP0 T32
Volume of data held in the EEPROM
Type
FP0 C10, C14, C16, FP−e
FP0 C32, SL1
FP0 T32
Because the initial data in the EEPROM is not fixed, caution is required when reading data that has not been
written to the EEPROM.
Flag conditions
・Error flag (R9007):
・Error flag (R9008):
3 − 34
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
Memory area
S1
K0 to K9
K0 to K95
K0 to K255
Volume that can be read
640 words
6,144 words
16,384 words
Turns on and stays on when:
Turns on for an instant when:
− The address specified by S1 does not exist in the EEPROM area.
− The area specified by S2 exceeds the limit of the EEPROM area.
− The area is exceeded when blocks specified by D and subsequent
parameters are transferred.
S2
K1 to K10
K1 to K96
K1 to K256
FP0/FP−e
D
DT0 to DT1595
DT0 to DT6080
DT0 to DT16320