Configuring The Delay For Applying The Routing Policy - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
l
l
You can run related commands to set the waiting time as required.
Pre-configuration Tasks
None.
Data Preparation
To configure the valid time of the routing policy, you need the following data.
No.
1

10.7.2 Configuring the Delay for Applying the Routing Policy

When modifying multiple cooperative routing policies, you need to configure the delay for
applying a routing policy.
Context
Perform the following steps on the router on which the delay for applying routing policy needs
to be changed:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
route-policy-change notify-delay delay-time
The delay for applying the routing policy is set.
The delay ranges from 1 to 180, in seconds.
By default, the RM immediately notifies the protocol of applying the new policy when the routing
policy changes.
----End
10.7.3 Checking the Configurations
After the delay for applying a routing policy is configured, you can check the configuration.
Issue 02 (2014-09-30)
If the valid time of the routing policy is configured, when the commands used to configure
the routing policy change, the RM does not notify various protocols of immediately
processing the changes. Instead, the RM waits for a certain period, and then notifies various
protocols of applying the changed routing policy.
If the routing policy changes again during the waiting time, the RM resets the timer.
Data
Delay for applying the routing policy
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Routing Policy Configuration
1250