Checking The Configurations - Huawei Quidway NetEngine80E Configuration Manual

HUAWEI NetEngine80E/40E Router
Configuration Guide - IP Routing
----End

10.5.6 Checking the Configurations

After filters are applied to advertised routes, you can check information about the routing table
of each protocol.
Prerequisites
Applying filters to advertised routes has been configured.
Procedure
l
l
l
l
l
----End
10.6 Applying Filters to Imported Routes
By applying the related filters of routing policies to routing protocols, you can filter imported
routes.
Issue 02 (2014-09-30)
Return to the system view.

4.

Run:
bgp { as-number-plain | as-number-dot }
The BGP view is displayed.
5. Run:
ipv4-family unicast
The IPv4 unicast address family view is displayed.
6. Run:
peer { group-name | ipv4-address } filter-policy { acl-number | acl-name
acl-name } export
The filtering policy is configured for routes advertised to the peers or peer groups.
Run the display rip process-id route command to check information about the RIP routing
table.
Run the display ospf [ process-id ] routing command to check information about the OSPF
routing table.
Run the display isis [ process-id ] route command to check information about the ISIS
routing table.
Run the display bgp routing-table command to check information about the BGP routing
table.
Run the display ip routing-table command to check information about the public IPv4
routing table.
Run the display ip routing-table command on the neighboring router. You can find that
the routes that meet the matching rules set on the neighboring router are filtered or the
actions defined by the apply clauses are performed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
10 Routing Policy Configuration
1245