Configuring The Interface With Ppp Encapsulation; Configuring The Interface With Hdlc Encapsulation; Configuring The Interface With Fr Dlci Or Fr Port Mode Encapsulation - HP HSR6800 Configuration Manual

Configuring the interface with PPP encapsulation

Step
1. Enter system view.
2. Enter interface view.
3. Configure the link layer
protocol.

Configuring the interface with HDLC encapsulation

Step
1. Enter system view.
2. Enter interface view.
3. Configure the link layer
protocol.
Configuring the interface with FR DLCI or FR port mode
encapsulation
Step
1. Enter system view.
2. Enter interface view.
3. Configure the link layer
protocol.
4. Enter FR point-to-point
subinterface view.
5. Create a virtual circuit.
Command
system-view
interface { serial | pos } number
link-protocol ppp
Command
system-view
interface { serial | pos } number
link-protocol hdlc
Command
system-view
interface { serial | pos }
interface-number
link-protocol fr [ nonstandard |
ietf ]
interface { serial | pos }
interface-number.subnumber p2p
fr dlci dlci-number
156
Remarks
N/A
N/A
Optional.
PPP by default.
Remarks
N/A
N/A
PPP by default.
Remarks
N/A
After you configure FR DLCI or
FR port mode encapsulation on a
serial interface, you must use the
reset fr inarp command to clear
FR dynamic address mappings
between the PE and the CE. For
more information about the reset
fr inarp command, see Layer
2—WAN Command Reference.
By default, the link layer protocol
of an interface is PPP.
Required for FR DLCI
encapsulation.
By default, no virtual circuit
exists.
Required for FR DLCI
encapsulation.
The DLCI number must be the
same as that configured on the
connected CE.