160 Appendix
15.1.1.2.14 "Configuration of NTP Client" Page
The settings for the NTP service are shown on the "Configuration of NTP Client"
page.
"NTP Client Configuration" Group
Table 93: WBM "Configuration of NTP Client" Page – "NTP Client Configuration" Group
Parameters
Service enabled
Update interval (sec)
Time Server <n>
Additionally assigned
(DHCP)
To update the time regardless of interval, click the [Update Time] button.
Click the [Submit] button to apply the changes. The changes take effect
immediately.
Manual
Version 1.1.0, valid from FW Version 03.08.07(20)
751-9301 Compact Controller 100
Explanation
Enable/disabled time update.
Specify the update interval of the time server.
Enter here the IP addresses of up to 4 time servers.
Time server No. 1 is queried first. If no data is
accessible via this server, time server No. 2 is
queried, etc.
The NTP servers assigned if necessary by DHCP
(or BootP) are displayed. If no NTP server has been
assigned by DHCP (or BootP), "(No additional
servers assigned)" is displayed.
WAGO I/O System Compact