Configuration Using "Wago Ethernet Settings; Figure 51: "Wago Ethernet Settings" - Start Screen - WAGO I/O System 750 Manual

WAGO I/O System 750
750-8210/040-000 PFC200; G2; 4ETH; XTR
</dg_

Configuration using "WAGO Ethernet Settings"

8.8.3
The "WAGO Ethernet Settings" program enables you to read system information
about your controller, make network settings and enable/disable the Web server.
Observe the software version!
To configure the controller, use at least Version 6.4.1.1 dated 2015-06-29 or
newer of "WAGO Ethernet Settings"!
You must select the corresponding interface after launching the "WAGO
ETHERNET Settings".
A connection can be established via the service interface using configuration
cable 750-923 or 750-923/000-001 or via the ETHERNET interfaces.
Figure 51: "WAGO Ethernet Settings" – Start Screen
For this, click "Settings" and then "Communication".
In the "Communication settings" window that then opens, adapt the settings to
your needs.
Version 1.7.0, valid from FW Version 04.01.10(23)
Commissioning 129
Manual