Input Shaft Speed Sensor Removal And Installation; Input Shaft Speed Sensor Inspection; Transmission Fluid Temperature Sensor Installation - Suzuki Liana RH418 Supplementary Service Manual

5A-70 Automatic Transmission/Transaxle:
Input Shaft Speed Sensor Removal and
Installation
Removal
1) Disconnect negative cable at battery.
2) Disconnect input shaft speed sensor connector (2).
3) Remove input shaft speed sensor (1) by removing its
bolt.
Installation
1) Apply A/T fluid to input shaft speed sensor O-ring.
2) Install input shaft speed sensor (1) to A/T case and
tighten bolt to specified torque.
Tightening torque
Input shaft speed sensor bolt (a): 5.5 N·m (0.55
kgf-m, 4.0 lb-ft)
3) Connect input shaft speed sensor connector (2) to
input shaft speed sensor (1).
4) Connect negative cable to battery.

Input Shaft Speed Sensor Inspection

1) Disconnect negative cable at battery.
S3RH0B5106011
2) Disconnect input shaft speed sensor connector (2).
3) Check resistance between input shaft speed sensor
(1) terminals.
Input shaft speed sensor resistance
Standard: 387 – 473 Ω at 20 °C (68 °F)
I2RH01510054-01
Transmission Fluid Temperature Sensor
Inspection
1) Lift up vehicle.
2) With engine is cool, remove drain plug and drain A/T
fluid.
3) Install drain plug. (Refer to "A/T Fluid Change".)
4) Disconnect fluid cooler inlet hose (outlet from fluid
cooler) from pipe, and remove A/T fluid cooler pipe
(lower side).
5) Remove A/T side cover.
6) Disconnect valve body connector (1).
I2RH01510055-01
S3RH0B5106012
I2RH01510056-01
S3RH0B5106013