Output Shaft Speed Sensor Removal And Installation - Suzuki Liana RH418 Supplementary Service Manual

5) Check that engine starts in "N" and "P" ranges but it
doesn't start in "D", "2", "L" or "R" range. Also, check
that back-up lamp turn ON in "R" range.
(a)
1
Output Shaft Speed Sensor Removal and
Installation
Removal
1) Disconnect negative cable at battery.
2) Disconnect output shaft speed sensor connector (2).
3) Remove output shaft speed sensor (1) by removing
its bolt.
3
Blank "L"
"2"
"D"
"N"
"R"
"P"
2
I3RH0B510025-01
S3RH0B5106009
I2RH01510051-01
Automatic Transmission/Transaxle:
Installation
1) Apply A/T fluid to output shaft speed sensor O-ring.
2) Install output shaft speed sensor (1) to A/T case and
tighten bolt to specified torque.
Tightening torque
Output shaft speed sensor bolt (a): 5.5 N·m (0.55
kgf-m, 4.0 lb-ft)
3) Connect output shaft speed sensor connector (2) to
output shaft speed sensor (1).
4) Connect negative cable to battery.
Output Shaft Speed Sensor Inspection
1) Disconnect negative cable at battery.
2) Disconnect output shaft speed sensor connector (2).
3) Check resistance between output shaft speed
sensor (1) terminals.
Output shaft speed sensor resistance
Standard: 648 – 792 Ω at 20 °C (68 °F)
5A-69
I2RH01510052-01
S3RH0B5106010
I2RH01510053-01