Table of Contents
Advertisement
C
4: R
HAPTER
UNNING THE
38
S
W
ETUP
IZARD
7 Configuring LAN setting: See
information.
IPoA Mode
Figure 19 IPoA Mode Screen
To setup the Firewall Router for use with a IPoA connection, use the
following procedure:
1 Enter the IP Address for WAN interface.
2 Enter the Subnet Mask for WAN interface.
3 Enter your Primary DNS Address and Secondary DNS address.
Your ISP may provide you with primary and secondary DNS
addresses. If they have been provided, enter the addresses in the
appropriate text boxes. If not, leave 0.0.0.0 in the boxes.
4 Enable NAT: Check the Enable NAT to enable this function which will
allow more than one PC in the LAN to connect the internet.
5 Click on Next to configure your LAN settings. See
this section for more information.
"LAN Settings"
in this section for more
"LAN Settings"
in
Advertisement
Table of Contents
