Configuring Auto-Dial - 3Com 3032 Configuration Manual

Configuring Special DCC
Functions
Table 763 Implement ISDN Caller Identification Callback (Client Configuration) in
Resource-Shared DCC
Operation
Configure the dial number for calling a
remote end
To configure the ISDN caller identification callback server in the resource-shared
DCC implementation, perform the following configuration in dialer interface view.
Table 764 Implement ISDN Caller Identification Callback (Server Configuration) in
Resource-Shared DCC
Operation
Configure the local end to implement
ISDN callback according to the ISDN caller
identification
Disable the local end to implement ISDN
callback according to the ISDN caller
identification
Configure the dialer number for calling a
remote end
By default, callback according to ISDN caller identification is not configured.
A dialer number should be configured on the dialer interface at server end
through the
dialer number
same as the dial-in dialer number.
Configuring ISDN leased line
This function can only be used with circular DCC and must be implemented after
circular DCC has been configured. ISDN leased line application is fulfilled through
establishing semipermanent ISDN MP connections. Such application requires that
a leased line has been established on the PBX of the telecommunication service
provider and has been connected to the remote device.
Perform the following configuration in dial interface (ISDN BRI or PRI interface)
view.
Table 765 Configure ISDN leased line for Circular DCC
Operation
Configure a B channel for ISDN leased line
connection
Delete the B channel for ISDN leased line
connection
By default, no B channel is configured for ISDN leased line connection.

Configuring auto-dial

This function can only be used with circular DCC. With a circular DCC, after the
router is started, the DCC will automatically attempt to dial the remote end of the
connection without requiring a triggering packet. If a normal connection cannot
be established with the remote end, DCC will automatically retry at a certain
interval. Compared with the auto-dial DCC triggered by packets, such connections
Command
dialer number [ dial-number ]
Command
dialer call-in remote-number [
callback ]
undo dialer call-in remote-number [
callback ]
dialer number [ dial-number ]
command, but it is not required to be exactly the
Command
dialer isdn-leased channel-number
undo dialer isdn-leased
channel-number
Configuring DCC 727