3Com Router 3000 Ethernet Family
Configuration Guide
Caution:
At the destination end, you must perform the following configurations:
[router] hwping-server enable
[router] hwping-server udpecho 169.254.10.2 9000
The address and port number configured using the hwping-server udpecho
command on the HWPing server for handling UDP test packets must be the same IP
address and port number configured in steps 3 and 4 described above.
4.5.7 SNMP Test
I. Introduction
SNMP test is performed to test the duration between the transmission of an SNMP
query and the receipt of the acknowledgement.
II. Configuration procedure
Note:
Steps 1 through 3 and 6 are required for an SNMP test and the remaining three steps
are optional. These operations are performed on the HWPing Client.
# Enable SNMP Client.
[router ] snmp-agent trap enable
# Enable HWPing Client.
[router] hwping-agent enable
# Step 1: Create an HWPing test group, given an administrator name "administrator"
and a test operations tag "snmp".
[router] Hwping administrator snmp
# Step 2: Set the test type to SNMP.
[router-hwping-administrator-snmp] test-type snmpquery
# Step 3: Configure a destination IP address, 169.254.10.2 for example.
[router-hwping-administrator-snmp] destination-ip 169.254.10.2
# Step 4: Configure the maximum number of tests.
[router-hwping-administrator-snmp] count 10
3Com Corporation
4-21
Chapter 4 HWPing Configurations