Connections And Startup; Electrical Connections; Connecting Power - Teledyne T400 User Manual

2.3

CONNECTIONS AND STARTUP

This Section presents the electrical (Section 2.3.1) and pneumatic (Section 2.3.2)
connections for setup and preparing for instrument operation.
2.3.1 E
LECTRICAL
Note

2.3.1.1 CONNECTING POWER

Attach the power cord between the instrument's AC power connector and a power outlet
capable of carrying at least the rated current at your AC voltage range and ensure that it is
equipped with a functioning earth ground. It is important to adhere to all safety and
cautionary messages.
083730400A DCN8130
C
ONNECTIONS
To maintain compliance with EMC standards, cables must be no
longer than 3 meters for all I/O connections.
WARNING – ELECTRICAL SHOCK HAZARD
• High Voltages are present inside the instrument's case.
• Power connection must have functioning ground connection.
• Do not defeat the ground wire on power plug.
• Turn off instrument power before disconnecting or connecting
electrical subassemblies.
Do not operate with cover off.
•
Ensure that installation provides access to disconnect power from
•
the instrument
CAUTION – AVOID DAMAGE TO THE INSTRUMENT
Ensure that the AC power voltage matches the voltage indicated on
the instrument's model/specs label before plugging it into line
power.
Teledyne API – Model T400 O Analyzer
3
25