Ford Corsar Repair Manual page 89

CYLINDER BLOCK
I
Punchmark side
Oil ring Top ring
expander
upper rail
2nd rlng lower rail
%
9%
9
8.
:0'
No.
2
Assembly (Cont'd)
3. Set piston rings as shown.
CRANKSHAFT
1. Set main bearings in their proper positions on cylinder block
and ,main bearing beam.
Confirm that correct main bearings are used. Refer to
"Inspection" of this section.
2. Install crankshaft and main bearing beam and tighten bolts
to the specified torque.
Prior to tightening bearing cap bolts, place bearing cap in
its proper position by shifting crankshaft in the axial
direction.
Tighten bearing cap bolts gradually in two or three stages.
Start with center bearing and move outward sequentially.
After securing bearing cap bolts, make sure crankshaft
turns smoothly by hand.
3. Measure crankshaft end play.
Crankshaft end play:
Standard
0.05
-
0.18 mm (0.0020
-
0.0071 in)
Limit
0.3 mm (0.012 in)
If beyond the limit, replace bearing with a new one.