Ford Corsar Repair Manual page 161

ENGINE COOLING SYSTEM
40
-
54 ft-lb)
SLC764
Water Pump
REMOVAL AND INSTALLATION
1. Drain coolant from radiator.
2. Remove cylinder block drain plug located at left rear of
cylinder block and drain coolant.
CAUTION:
When removing water pump assembly, be careful not to
get coolant on timing belt.
e
Water pump cannot be disassembled and should be
replaced as a unit.
After installing water pump, connect hose and clamp
securely, then check for leaks using radiator cap tester.
INSPECTION
1. Check for badly rusted or corroded body assembly and vane.
2. Check for rough operation due to excessive end play.