Ford Corsar Repair Manual page 623

PRECAUTIONS AND PREPARATION
Precautions
When installing each rubber part, final tightening must be
carried out under un1ade.n condition* with tires on ground.
*
Fuel, radiator coolant and engine oil full. Spare tire,
jack, hand tools and mats in designated positions.
When removing each suspension part, check wheel align-
ment and adjust if necessary.
Always tension brake pipes and fittings t o specified torques
(refer S.D.S.).
Where fitted, self-locking (nyloc) nuts must not be re-used,
they must be renewed.
Preparation
SPECIAL SERVICE TOOLS
Tool sup~lier: Litchfield
I
Tool number
Tool name
Description
E2237
Ball joint remover
Removing tie-rod outer end and lower
ball joint
E2M 1 OF
Spring compressor
Press plates -wheel bearing removal
Removing and installing coil spring
J34296 (Left Hand)
J34297 (Right Hand)
Differential side oil
seal protector
E7422 (use with
E7 177-5)
Installing drive shaft
E7 177-5 (use with
E7422)
E7 177-8
Wheel bearing
Handle
-
wheel bearing removal/installation.
Drift adapter
-
wheel bearing removal/installation.
@
Press tool
-
wheel bearing removal/installation.
0
Press tool wheel bearing removal/installation.
€D
removal/installation
tools