Ford Corsar Repair Manual page 65

O.K.
ocker arm with
S E M 8 7 8 B
N.G.
S E M 8 6 8 8
CAUTION
:
a
When installing sliding parts such as rocker arms, cam-
shaft and oil seal, be sure to apply new englne oil on their
sliding surfaces.
a
When tightening cylinder head bolts and rocker shaft bolts,
apply new engine oil to thread portions and seat surfaces
of bolts.
a
Hydraulic valve lifters are Installed in each rocker arm. If
hydraulic valve lifter is kept on its side, even when
installed in rocker arm, there is a posslblllty of air entering
it. After removal, always set rocker arm straight up, or
when laying it on its side, have it soak in'new englne oil.
a
Do not disassemble hydraulic valve lifter.
a
Attach tags to valve lifters so as not to mix them up.
Removal
1. Drain coolant from radiator.
2. Relieve fuel pressure to zero
Refer to ES section "FUEL INJECTION CONTROL SYSTEM
INSPECTION".
3. Remove the following parts:
a
Exhaust manifold
a
Air duct
a
lntake manifold collector
a
lntake manifold stay
4. Disconnect hoses.
a
Vacuum gallery hoses, which are installed on intake manifold.
a
Fuel tube hoses
a
5. Disconnect water hoses as shown in figure.