Ford Corsar Repair Manual page 766

BODY ALIGNMENT
All dimensions indicated in figures are actual ones.
When a tram tracking gauge is used, adjust both pointers to equal length and check the pointers and
gauge itself to make sure there is no free play.
When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
Measurements should be taken a t the center of the mounting holes.
An asterisk ( * ) following the value a t the measuring point indicates that the measuring point on the other
side is symmetrically the same value.
The coordinates of the measurement points are the distances measured from the standard line of "X",
IIylf and UZ#l.
"X"
"Y"
m.
"X"
: L.H. side
:
R.H. side
I
"Y"
Engine Compartment
MEASUREMENT
"X" : Vehicle center
"Y"
: Center line of front axle
"2"
: Imaginary base line
[200 mm (7.87 in) below
datum line
("02"
at
design plan)]
I
Unit: mm (in)