Ford Corsar Repair Manual page 640

FRONT AXLE
-
Drive Shaft
Disassembly (Cont'd)
8
Press support bearing out of retainer.
Inspection
Thoroughly clean all parts in cleaning solvent, and dry with
compressed air. Check parts for deformation or other damage.
DRIVE SHAFT
Replace drive shaft if it is twisted, bent or cracked.
BOOT
Check boot for fatigue, cracks, or wear. Replace boot with new
boot bands.
JOINT ASSEMBLY (Transaxle side)
8
Check spider assembly for needle bearing and washer
damage. Replace if necessary.
Check roller surfaces for scratches, wear or other damage.
Replace if necessary.
8
Check serration for deformation. Replace if necessary.
8
Check slide joint housing for any damage. Replace if
necessary.
JOINT ASSEMBLY (Wheel side)
Replace joint assembly if it is deformed or damaged.
SUPPORT BEARING
Make sure wheel bearing rolls freely and is free from noise,
cracks, pitting or wear.
SUPPORT BEARING BRACKET
Check support bearing bracket for cracks.
Assembly
After drive shaft has been assembled, make sure it moves
smoothly over its entire range without binding.
Use GENUINE GREASE or equivalent after every overhaul.