Ford Corsar Repair Manual page 631

FRONT AXLE
-
Wheel Hub and Knuckle
Removal
Remove wheel bearing lock nut while depressing brake
pedal.
Remove brake caliper assembly.
Brake hose need not be disconnected from brake caliper. Be
careful not to depress brake pedal, or piston will pop out.
Make sure brake hose is not twisted.
Separate tie-rod from knuckle with Tool.
Install stud nut conversely on'stud bolt to prevent damage to
stud bolt.
Loosen drive shaft from knuckle.
Remove bolts and nuts as shown at left.
Make a matching mark before removing adjusting pin.
Draw knuckle assembly from drive shaft. Support drive shaft
assembly to prevent damage to rubber boot.
FA- 1 0