Ford Corsar Repair Manual page 439

ASSEMBLY
14. Place magnet on clutch housing.
shift selector
- For 1 st 81 2nd shift
For
3rd & 4th shift
' I SMT017B
-
15. If
bearing preload was adjusted, install selected shim(s) into
transmission case. 'Install oil gutter.
To aid in installation of transmission case, place shift
selector in the 1st and 2nd shift bracket or between 1st
and 2nd bracket and 3rd and 4th bracket.
16. Apply sealant to mating surface of transmission case and
install it.
17. Install position switch.
18. Apply sealant to threads of check plugs. Install balls, springs
and plugs.
19. After assembly, check that you can shift into each gear
smoothly.
20. Measure total turning torque using E7 187 adapter.
Total turning torque (New bearing):
8.8
-
21.6 N-m (90
-
220 kg-cm, 78
-
191 in-lb)
When old bearing is used again, preload will be slightly
less than the above. Make sure torque Is close to the
specified range.