Ford Corsar Repair Manual page 851

HEADLAMP
Aiming Adjustment (Cont'd)
"H": Horizontal
center line
of headlamps
0
0
/ 0
Vertical centerline
&
=
ACCEPTABLE RANGE
LOW BEAM
1. Turn headlamp low beam on.
2.
Use adjusting screws to perform aiming adjustment.
First tighten the adjusting screw all the way and then
make adjustment by loosening the screw.
a. Adjust headlamps so that main axis of light is parallel to
center line of body and is aligned with point P shown in
illustration.
b. Dotted lines i n illustration show centre of headlamp.
"H": Horizontal center line of headlamps
"WL": Distance between each headlamp center
"L": 5,000 mm (196.85 in)
rrC!r: 50 mm (1.97 in)
Intermittent Amp. Check
Connect as shown in the figure at left.
If test lamp blinks when connecting terminal
@
to battery
@
terminal and disconnecting terminal
@
from battery
@
terminal, intermittent amp. is normal.