Ford Corsar Repair Manual page 15

l
HOW TO FOLLOW FLOW CHART IN TROUBLE DIAGNOSES
Example
View from terminal
Connector symbol
@
Single line
Direction mark
m,
View from harness side
\
Connector Direction mark
M
I
SG 1364
HOW TO FOLLOW THIS FLOW CHART
Work and diagnostic procedure
Start to diagnose a problem using procedures indicated in
enclosed blocks, as shown in the following example.
9
4
CHECK POWER SUPPLY.
1) Turn ignition switch "ON".
2)
Check voltage between
terminal
@
and ground.
Battery voltage should exist.
1 -
Check item being performed.
Procedure, steps or
measurement results
l
O.K.
Measurement results
Required results are indicated in bold type in the corre-
sponding block, as shown below:
These have the following meanings:
Battery voltage
+
1 1
-
14V or approximately 12V
Voltage: Approximately O V
+
Less than 1V
@l
Cross reference of work symbols in the text and
illustrations
Illustrations are provided as visual aids for work procedures.
For example, symbol indicated in the left upper portion
of each illustration corr~sponds with the symbol in the
flowchart for easy identification. More precisely, the proce-
dure under the "CHECK POWER SUPPLY" outlined previ-
ously is indicated by an illustration
@l
Symbols used in illustrations
Symbols included in illustrations refer to measurements or
procedures. Before diagnosing a problem, familiarize your-
self with each symbol.
Direction mark
A direction mark is shown to clarify the side of connector (ter-
minal side or harness side).
Direction marks are mainly used in the illustrations indicating
terminal ins~ection.
M
: View from terminal side
...
T.S.
All connector symbols shown from the terminal side are
enclosed by a single line.
M
: View from harness side
...
H.S.
All connector symbols shown from the harness side are
enclosed by a double line.