Ford Corsar Repair Manual page 781

Valve press p o i n t
N.G.
s k 1 ~ 9 1 9 A
Note:
m
State and Federal Regulations may affect any operations involv-
ing refrigerant gas. Care should be taken to ensure that these are
conformed with.
WARNING:
Always wear eye protection when working around the
system.
m
Always be careful that refrigerant does not come in
contact with your skin.
m
Keep refrigerant containers stored below 40°C (104OF) and
never drop from high places.
m
Work in well-ventilated area because refrigerant gas
evaporates quickly and breathing may become difficult due
to the lack of oxygen.
m
Keep refrigerant away from open flames because poison-
ous gas will be produced if it burns.
m
Do not increase can temperature beyond 40°C (104OF) in
charging.
m
Do not heat refrigerant can with an open flame. There is
danger that can will explode.
CAUTION:
Do not use steam to clean surface of condenser or
evaporator. Be sure to use cold water or compressed air.
m
Compressed air must never be used to clean a dirty line.
Clean with refrigerant gas.
Do not use manifold gauge whose press point shape is
different from that shown. Otherwise, insufficient evacuat-
ing may occur.
Do not over-tighten service valve cap.
Do not allow refrigerant to rush out. Otherwise, compres-
sor oil will be discharged along with refrigerant.