Ford Corsar Repair Manual page 676

BRAKE PEDAL AND BRACKET
i
-Stays inside
I
I
6
I
? I
Input rod Clevis pin
S B R 9 3 0
Adjustment
Check brake pedal free height from dash reinforcement panel.
Adjust if necessary.
H: Free height
Refer to S.D.S.
D: Depressed height
Refer to S.D.S.
Under force of 490 N (50 kg, 110 Ib)
with engine running
C: Clearance between pedal stopper and threaded
end of stop lamp switch
0.3
-
1.0 mm (0.012
-
0.039 in)
A:
Pedal free play
1
-
3 mm (0.04
-
0.12 in)
1. Adjust pedal free height with brake booster input rod. Then
tighten lock nut.
Make sure that tip of input rod stays inside.
2. Adjust clearance "C" with stop lamp switch. Then tighten
lock nuts.
3. Check pedal free play.
Make sure that stop lamp is off when pedal is released.
4. Check brake pedal's depressed height while engine is
running.
If depressed height is below specified value, check brake
system for leaks, accumulation of air or any damage to
components (master cylinder, wheel cylinder, etc.); then
make necessary repairs.