Ford Corsar Repair Manual page 538

REMOVAL AND INSTALLATION
E l
Removal
Remove battery and its bracket
Drain A.T.F. by removing drain plug.
Disconnect drive shafts.
-
Refer to section FA.
Remove bolts securing torque converter to drive plate.
Remove those bolts by turning crankshaft.
Plug up opening such as oil charging pipe hole, etc.
Installation
Drive plate runout
Maximum allowable runout:
0.5 mm (0.020 in)
If this runout is out
of
allowance, replace drive plate with
ring gear.
When connecting torque converter to transaxle, measure
distance "A" to be certain that they are correctly assembled.
Distance "A":
19.0
m m or more
Install converter to drive plate.
After converter is installed to drive plate, rotate crankshaft
several turns and check to be sure that transaxle rotates
freely without binding.
Torque engine t o transaxle bolts as shown on following page.
Re-install any part removed.
Check fluid level in transaxle.
Move selector lever through all positions to be sure that
transaxle operates correctly.
With parking brake applied, rotate engine at idling. Move
selector lever through "N" to "D", to "2", to "1" and to "R".
A slight shock should be felt by hand gripping selector each
time transaxle is shifted.
Perform road test.
-
Refer to "Road Testing".