Ford Corsar Repair Manual page 568

REPAIR FOR COMPONENT PARTS
I
RL4F02A
1
Dial gauge
G
Final Drive (Cont'd)
3. Remove bearing using E 1673MT puller with E6673 plates and
E7422 & E7 177-5 drift and plug.
4. Remove differential side bearing inner cone using E7 158 puller
with E7009 leg and plug set.
INSPECTION
Check mating surface of differential case, side gears and
pinion mate gears. Replace as required.
a
Check tapered roller bearings for wear, scratches, pitching
or flaking.
ASSEMBLY
1. Install side gear and thrust washer in differential case.
2. Install pinion mate gear and thrust washer in differential case
while rotating them.
3. Insert pinion mate shaft.
When inserting, be careful not to damage pinion mate
washers.
4. Measure clearance between side gear and differential case
with washer following the procedure below:
a. Set Tool and dial gauge on side gear.