Ford Corsar Repair Manual page 77

CYLINDER HEAD
Installation (Cont'd)
6. Check hydraulic valve lifter.
(1) Push hydraulic valve lifter forcefully with your finger.
Be sure to check it with rocker arm in its free position.
(2) If valve lifter moves more than 1 mm (0.04 in), air may be inside
of it.
(3) Bleed air off by running engine at 1,000 rpm under no-load for
about 20 minutes (After completing installation of all parts).
(4)
If hydraulic valve lifters are still noisy, replace them and bleed
air off again in the same manner as in step (3).
9. Install any parts removed.
0
0
@ L
@l0
6 6
SEM591 C
SEM592C
7. Install rocker cover.
m
When installing rocker cover, be sure to avoid interference
between rocker cover and rocker arms.
8. Tighten bolts as shown below:
(1) Temporarily tighten 2 bolts to 3 N-m (0.3 kg-m, 2.2 ft-lb) in
order as shown in figure.
(2) Tighten all bolts to 7 to 10 Nom (0.7 to 1.0 kg-m, 5.1 to 7.2 ft-lb)
as shown in figure.
(3) Retighten
4
bolts to 7 to 10 Nom (0.7 to 1.0 kg-m, 5.1 to 7.2
ft-lb) as shown in figure.