Ford Corsar Repair Manual page 130

ENGINE OVERHAUL --Inspection-
Taper: A
-
B
Out-of-round:
X
-
Y
CONNECTING ROD BEND AND TORSION
Bend and torsion:
Limit 0.1 mm (0.004 in) per 100 mm
(3.94 in) length
CRANKSHAFT
1.
Check crankshaft journals for score, bias, wear or cracks.
2 . Check journals with a micrometer for taper and out-of-round.
Out-of-round (X
-
Y
1:
Less than 0.03 mm (0.0012 in)
Taper (A
-
B):
Less than 0.03 mm (0.001 2 in)
a.
Fillet roll should not be reground.
L: Pin journal
2.5 mm (0.098 in)
Main journal
2.0 mm (0.079 in)
b. Refer to S.D.S. for regrinding crankshaft and available service
parts.
3. Check crankshaft runout.
Runout [T.I.R. (Total Indicator Reading)]
:
Less than 0.05 mm (0.0020 in)