Ford Corsar Repair Manual page 76

CYLINDER HEAD
p 1
Liquid gasket
4
* p
3
mm
(0.12
in) diameter
(liquid gasket) s ~ M 9 3 1 B
W
N.G.
W
Good
SEM933B
Installation (Cont'd)
3. Set chain on camshaft sprocket by aligning each mating
mark. Then install camshaft sprocket to camshaft.
4. Tighten camshaft sprocket bolt whilst holding gear with
E7181A
5. lnstall rubber plugs as follows:
(1) Apply liquid gasket to rubber plugs.
Rubber plugs should be replaced with new ones.
a
Rubber plugs should be installed within 5 minutes of
applying liquid gasket.
(2) Install rubber plugs, then move them with your fingers to
uniformly spread the gasket on cylinder head surface.
Rubber plugs should be installed flush with the surface.
Do not start the engine for 30 minutes after installing
rocker cover.
Wipe clean excessive liquid gasket from cylinder head top
surface.