Ford Corsar Repair Manual page 134

ENGINE OVERHAUL -Assembly
-
1 ~ ~ 2 0 ~
I
r
Englne
front
S E M 7 9 4 A
Top rlng
011 rlng
(Expander)
Second rang
0 1 1
rtng (Lower rail)
E M 7 2 5
2. Apply engine oil to main bearing surfaces on both sides of
cylinder block and cap.
3.
Install crankshaft and main bearing caps and tighten bolts to
specified torque.
(o)
: Main bearing cap bolt
44
-
54 N-m
(4.5
-
5.5 kg-m, 33
-
40 ft-lb)
Arrange the parts so that the indicated number on bearing
cap i s in a row from the front of engine.
Prior to tightening bearing cap bolts, place bearing cap in
proper position by shifting crankshaft in the axial direction.
Tighten bearing cap bolts gradually i n t w o or three
stages in the sequence shown.
After s e c u r ~ n r m r ~ n g cap bolts, make sure that crankshaft
turn smoothly.
4.
Measure crankshaft end play at center bearing.
Crankshaft end play:
Limit
0.30 mm (0.01 18 in)
Set piston ring as shown.
5, Install pistons with connecting rods.
(1
) Install them into corresponding cylinder using Tool.
Be careful not t o scratch cylinder wall with
connecting rod.
Apply engine oil to cylinder wall, piston and bearing.
Arrange s o that the front mark on piston head faces to the
front of engine.