Ford Corsar Repair Manual page 748

INSTRUMENT PANEL
Instrument Cluster Removal
lnstrument Case Removal
Removal
1. Switch ignition "OFF" and remove key.
2. Remove steering column shroud assembly and cover ignition/
indicator switch assembly with suitable material.
3. Remove ashtray and cigarette lighter to gain access to screws
for removal at lower edge of dash support cover.
4. Remove screws directly above heater air/con. panel
assembly.
5. Remove bolts from steering column support bracket allowing
column to drop.
6.
Select and remove screws retaining cluster lid at lower edge.
7. Grasp upper edge of cluster lid and pull firmly towards rear of
car (cluster lid is retained by metal spring clips at top edge) to
remove.
8. Disconnect cigarette lighter wires and tilt cluster lid bottom
edge up to disconnect switch harness plugs.
Note: Take note of harness connection plugs and wiring to
ensure that hazard warning and fog lamp switch (where
fitted) connectors are not reversed on reassembly.
9.
Remove upper and lower screws retaining instrument fascia.
Carefully pry upper edge above instruments out, grasp and
feed out instrument fascia..
Disconnect clock harness connector and slide fascia t o left of
vehicle to remove.
10. Remove instrument case retaining screws. Pull bottom edge
of case out and tilt up to remove harness connectors.
Installation
Reverse order of above.