Ford Corsar Repair Manual page 572

REPAIR FOR COMPONENT PARTS
p i i q
e--
Rotor support ring
Vane ring Punch mark
SAT041C
SATOOOA
Oil Pump (Cont'd)
3. Assemble rotor, vanes, rotor support ring and vane rings.
Pay attention to direction of rotor.
4. Install oil pump cover.
Tighten down cover evenly 'in a criss-cross type pattern.
5. Rotate the pump when it has been assembled to ensure
that all parts have been correctly assembled.
6. Install seal rings.
Refer to the figure at left for proper locations of the two
different types of seal rings.
These seal rings can be cut or deformed if they are
improperly seated in their grooves when the drum is
installed. Clean the ring grooves carefully and fill them
with petroleum jelly. Then install the rings making sure
they fit into the grooves as tightly as possible.