Ford Corsar Repair Manual page 831

STARTING SYSTEM -Starter-
KA24E
J
Assembly
Apply high-temperature grease to lubricate the bearing, gears
and frictional surface when assembling the starter.
Carefully observe the following instructions.
Pinion stopper
Switch
.
7
--tt
Clearance
"P"
Adjusting plate
Plate thicknon
0.5 m m (0.020 in)
0.8 mm (0.031 in)
PINION PROTRUSION LENGTH ADJUSTMENT
Hitachi
With pinion driven out by magnetic switch, push pinion back to
remove slack and measure clearance
"
Q " between the front
edge of the pinion and the pinion stopper.
Clearance
"
Q ":
Refer to S.D.S.
Not in the specified value
...
Adjust with adjusting plate.
Mitsubishi
Compare movement " Q " in height of pinion when it is pushed
out with magnetic switch energized and when it is pulled out by
hand until it touches stopper.
Movement
"
Q ":
Refer to S.D.S.
Not in the specified value
...
Adjust by adjusting plate.